利博·(集团)有限公司官网

Features

Dual core

? 32-bit Arm? Cortex?-M7 core with doubleprecision

FPU and L1 cache: 16 Kbytes of data

and 16 Kbytes of instruction cache; frequency

up to 480 MHz, MPU, 1027 DMIPS/

2.14 DMIPS/MHz (Dhrystone 2.1), and DSP

instructions

? 32-bit Arm? 32-bit Cortex?-M4 core with FPU,

Adaptive real-time accelerator (ART

Accelerator?) for internal Flash memory and

external memories, frequency up to 240 MHz,

MPU, 300 DMIPS/1.25 DMIPS /MHz

(Dhrystone 2.1), and DSP instructions

Memories

? Up to 2 Mbytes of Flash memory with readwhile-

write support

? 1 Mbyte of RAM: 192 Kbytes of TCM RAM (inc.

64 Kbytes of ITCM RAM + 128 Kbytes of

DTCM RAM for time critical routines),

864 Kbytes of user SRAM, and 4 Kbytes of

SRAM in Backup domain

? Dual mode Quad-SPI memory interface

running up to 133 MHz

? Flexible external memory controller with up to

32-bit data bus: SRAM, PSRAM,

SDRAM/LPSDR SDRAM, NOR/NAND Flash

memory clocked up to 125 MHz in

Synchronous mode

? CRC calculation unit

Security

? ROP, PC-ROP, active tamper

General-purpose input/outputs

? Up to 168 I/O ports with interrupt capability

Reset and power management

? 3 separate power domains which can be

independently clock-gated or switched off:

– D1: high-performance capabilities

– D2: communication peripherals and timers

– D3: reset/clock control/power management

? 1.62 to 3.6 V application supply and I/Os

? POR, PDR, PVD and BOR

? Dedicated USB power embedding a 3.3 V

internal regulator to supply the internal PHYs

? Embedded regulator (LDO) to supply the digital

circuitry

? High power-efficiency SMPS step-down

converter regulator to directly supply VCORE

and/or external circuitry

? Voltage scaling in Run and Stop mode (6

configurable ranges)

? Backup regulator (~0.9 V)

? Voltage reference for analog peripheral/VREF+

? 1.2 to 3.6 V VBAT supply

? Low-power modes: Sleep, Stop, Standby and

VBAT supporting battery charging

Low-power consumption

? VBAT battery operating mode with charging

capability

? CPU and domain power state monitoring pins

? 2.95 μA in Standby mode (Backup SRAM OFF,

RTC/LSE ON)

Clock management

? Internal oscillators: 64 MHz HSI, 48 MHz

HSI48, 4 MHz CSI, 32 kHz LSI

? External oscillators: 4-48 MHz HSE,

32.768 kHz LSE

? 3× PLLs (1 for the system clock, 2 for kernel

clocks) with Fractional mode

Interconnect matrix

? 3 bus matrices (1 AXI and 2 AHB)

? Bridges (5× AHB2-APB, 2× AXI2-AHB)

4 DMA controllers to unload the CPU

? 1× high-speed master direct memory access

controller (MDMA) with linked list support

? 2× dual-port DMAs with FIFO

? 1× basic DMA with request router capabilities

Up to 35 communication peripherals

? 4× I2Cs FM+ interfaces (SMBus/PMBus)

? 4× USARTs/4x UARTs (ISO7816 interface,

LIN, IrDA, up to 12.5 Mbit/s) and 1x LPUART

? 6× SPIs, 3 with muxed duplex I2S audio class

accuracy via internal audio PLL or external

clock, 1x I2S in LP domain (up to 150 MHz)

? 4x SAIs (serial audio interface)

? SPDIFRX interface

? SWPMI single-wire protocol master I/F

? MDIO Slave interface

? 2× SD/SDIO/MMC interfaces (up to 125 MHz)

? 2× CAN controllers: 2 with CAN FD, 1 with

time-triggered CAN (TT-CAN)

? 2× USB OTG interfaces (1FS, 1HS/FS) crystalless

solution with LPM and BCD

? Ethernet MAC interface with DMA controller

? HDMI-CEC

? 8- to 14-bit camera interface (up to 80 MHz)

11 analog peripherals

? 3× ADCs with 16-bit max. resolution (up to 36

channels, up to 3.6 MSPS)

? 1× temperature sensor

? 2× 12-bit D/A converters (1 MHz)

? 2× ultra-low-power comparators

? 2× operational amplifiers (7.3 MHz bandwidth)

? 1× digital filters for sigma delta modulator

(DFSDM) with 8 channels/4 filters

Graphics

? LCD-TFT controller up to XGA resolution

? Chrom-ART graphical hardware Accelerator?

(DMA2D) to reduce CPU load

? Hardware JPEG Codec

Up to 22 timers and watchdogs

? 1× high-resolution timer (2.1 ns max

resolution)

? 2× 32-bit timers with up to 4 IC/OC/PWM or

pulse counter and quadrature (incremental)

encoder input (up to 240 MHz)

? 2× 16-bit advanced motor control timers (up to

240 MHz)

? 10× 16-bit general-purpose timers (up to

240 MHz)

? 5× 16-bit low-power timers (up to 240 MHz)

? 4× watchdogs (independent and window)

? 2× SysTick timers

? RTC with sub-second accuracy and hardware

calendar

Debug mode

? SWD & JTAG interfaces

? 4-Kbyte Embedded Trace Buffer